Varial Kickflip 180

Every tutorial treats the varial kickflip as a kickflip and pop shove-it fused into one motion: the front foot sets up in a kickflip position (near the bolts, angled forward) while the back foot sits in the toe-side pocket of the tail to generate a controlled 180 scoop. The two most common failure points are over-scooping, which spins the board past 180 and makes it uncatchable, and turning the shoulders frontside during the pop, which throws the board out in front of the rider instead of keeping it centered underneath them. The front foot flicks straight forward (or slightly toe-side), never off to the side like a plain kickflip, because a sideways flick blocks the board's horizontal spin. Sources agree the fastest path to consistency is isolating the two halves: drill the back foot's 180 scoop alone (like a pop shove-it) and the front foot's flick-and-catch alone (stepping off with the back foot) before combining them under full commitment. Landing means catching once the rotation fully completes, then squaring the shoulders and centering weight over the board to roll away instead of slipping out.

• →Have kickflips and pop shove-its solid individually before attempting the varial kickflip; it is a direct combination of both
• →Place your front foot near the front bolts in a kickflip angle, and your back foot in the tail's toe-side pocket to load the scoop
• →Pop and scoop only enough for a clean 180; over-scooping spins the board too far and makes it nearly impossible to catch
• →Flick straight forward with your ankle as the board pops, not off to the side like a standard kickflip, so the flick does not block the board's rotation
• →Keep your shoulders and weight centered over the board through the pop; turning frontside kicks the board out in front of you instead of keeping it underneath you
• →Isolate the two motions while learning: drill the back foot's 180 scoop alone, then the front foot's flick-and-catch alone (stepping off with the back foot), before combining them
• →Give the board enough hang time to complete its full rotation before committing your feet; catching it at its highest point makes for the cleanest landing
• →If you land primo (on the board's edge), the board under-rotated; ease off if you over-rotate, add a touch more scoop if you under-rotate, and square your shoulders back to the board before landing

Synthesized from the top video tutorials. Watch them